By resection process, plane table station points are located in which y are taken as reference for locating remaining points of traverse.

A triangle is most commonly used shape in case of surveying as it covers an entire area in a framework which makes calculations easier.

Or than plane table surveying, remaining methods need a compass for initiating work in which it is not possible to access compass in a magnetic area. Plane table surveying can be employed re as it can be done without usage of compass.

resection method is employed for having a clear idea about station points. So, it requires proper orientation of table to continue furr. Error in orientation can be corrected by following classification methods.

The methods which are adopted in case of plane table surveying involve radiation, Intersection, resection and traversing, which are used based on type of output required.

Resection is done after table has been properly oriented. If re is any mistake in orientation, entire process will go wrong and may end up repeating again.

Plane table surveying, though having more methods involved, is not considered as preferable method because it may produce more amounts of errors when compared to or methods. But it is adopted when speed of method is considered.

Radiation process involves in recreating station to station distance in an enlarged manner. It requires a lot of time which makes it suitable only in case of small distances.

Since compass gives a rough output and orientation done by it isn?t accurate enough. So orientation by compass is employed in case of small scale works where speed of work is considered.

The method of intersection usually involves locating a station point and marking remaining points, followed by changing instrument to anor point and computing remaining points from which required distance between points can be found out with minimal effort.