1. These are vertical distances above a common datum, reference plane or point:

Plats Elevations Traverse Profiles

Answer

2.
A third angle orthographic projection of an object is given below. What is this object?

Triangle Trapezium Cone Frustrum of a cone

Hint Answer

3. The edges of a cube in isometric projection make angles of this many degrees with each or:

30° 60° 90° 120°

Answer

4. The maximum and minimum sizes of a feature are identified by a ________ tolerance.

Limits GD&T Reference Allowance

Answer

5. The 3-D commands on Modeling toolbar include __________.

Box Sphere Extrude All of the above

Answer

6. The offset distance for width (front to back) distance of auxiliary view is same distance of ________ in top view.

Width Height Length None of the above

Answer

7. The ________ tool on Dimension tool bar will place several dimensions at one time by using a selection box placed over several part features.

Linear Continue Baseline Quick Dimension

Answer

8. When using direct entry method to create a horizontal line exactly three inches long drafter should ________ first.

Pull the line from away from the starting point very carefully Insure that Ortho is on Enter 3 for the length of the line Read the coordinate position on the Dynamic Readout

Answer

9. Drafters should use a ________ in a section view of a mechanical part that includes cylindrical view of a threaded hole.

Center line Hatch line Poly line Dimension line

Answer

10. The architectural drafter usually begins a set of working drawings by creating ________ plan first.

Foundation Floor plan Elevations Building section

Answer

Nexttt

First angle projection	Third-angle projection
The object is kept in first quadrant	An object is assumed to be kept in third quadrant
Object lies between observer and plane of projection	A plane of projection lies between observer and object
The plane of projection is assumed to be Non-transparent	The plane of projection is assumed to be transparent.
Front (elevation) view is drawn above XY line	Front (elevation) view is drawn below XY line
Top (plan) view is drawn below XY line	Top (plan) view is drawn above XY line
Left view is projected on right plane and vice versa	Left view is projected on left plane itself
Followed in India, European countries	Followed in USA

Guest You need to login to ask any Questions from chapter Projection-of-Solids of Engineering-Drawing-MCQS

Chapter:

Elevations

Frustrum of a cone

120°

Limits

All of the above

Width

Quick Dimension

Insure that Ortho is on

Center line

Floor plan

All Chapters

Drawing Instruments

Lines, Lettering and Dimensioning

Scales

Geometrical Construction

Curves used in Engineering Practice

Orthographic Projections

Projection of Points

Projection of Lines

Projection of Planes

Projection of Solids

Section of Solids

Development & Intersection of Surfaces

Isometric Projection

Oblique & Perspective Projection

Engineering Drawing Important MCQS

Topics

Engineering Drawing Important MCQS

These are vertical distances above a common datum, reference plane or point:

A third angle orthographic projection of an object is given below. What is this object?

The edges of a cube in isometric projection make angles of this many degrees with each or:

The maximum and minimum sizes of a feature are identified by a ________ tolerance.

The 3-D commands on Modeling toolbar include __________.

The offset distance for width (front to back) distance of auxiliary view is same distance of ________ in top view.

The ________ tool on Dimension tool bar will place several dimensions at one time by using a selection box placed over several part features.

When using direct entry method to create a horizontal line exactly three inches long drafter should ________ first.

Drafters should use a ________ in a section view of a mechanical part that includes cylindrical view of a threaded hole.

The architectural drafter usually begins a set of working drawings by creating ________ plan first.

Guest
You need to login to ask any Questions from chapter Projection-of-Solids of Engineering-Drawing-MCQS