MCQ
If a material had a modulus of elasticity of 2.1 kgf/cm2 and a modulus of rigidity of 0.8 kgf/cm2 then what will be the …
Login to ask a question from Simple Stress and Strain
A rigid beam ABCD is hinged at D and supported by two springs at A and B as shown in the given figure. The beam carries a vertical load P and C. the stiffness of spring at A is 2K and that of B is K.
What will be the ratio of forces of spring at A and that of spring at B?
All Chapters — Structural Engineering
Simple Stress and Strain
Stresses in Members
Strain Energy and Resilience
Center of Gravity and Moment of Inertia
Shear Force and Bending Moment
Pure Bending
Shear Stress
Direct and Bending Stress
Slope and Deflection
Indeterminate Beams
Torsion
Plastic and Local Buckling Behaviour of Steel
Cables and Arches
Influence Lines and Approximate Analysis for Statically Determinate Structures
Deflections
Deflections Using Energy Methods
Displacement Method of Analysis: Slope-Deflection Equations
Displacement Method of Analysis: Moment Distribution
Influence line diagram mcqs
Structural engineering important exam questions
Structural engineering important exam questions II
Structural engineering important exam questions III
Plastic Analysis
Structural Engineering Loksewa Questions
Similar Questions
From Simple Stress and Strain · Structural Engineering
MCQ
A bar of 40mm dia and 40cm length is subjected to an axial load of 100 kN. It elongates by 0.005mm. Calculate the Poisso…
MCQ
How many elastic constants of a non homogeneous, non isotropic material will be?
MCQ
How can be the Poissons ratio be expressed in terms of bulk modulus(K) and modulus of rigidity(G)?
MCQ
What kind of elastic materials are derived from a strain energy density function?
MCQ
The law which states that within elastic limits strain produced is proportional to the stress producing it is known as _…
MCQ
Some structural members subjected to a long time sustained loads deform progressively with time especially at elevated t…
MCQ
The Poissons ratio of a material is 0.3. what will be the ratio of Youngs modulus to bulk modulus?
