Which of the following stresses are associated with the tightening of a nut on a bolt?
P. Crushing and shear stress in threads
Q. Bending stress due to the bending of bolt
R. Torsional shear stress due to frictional resistance between the nut and the bolt
Select the correct answer using the codes given below:

A rod, which tapers uniformly from 5cm diameter to 3cm diameter in a length of 50cm, is subjected to an axial load of 60…

What will be the minimum diameter of a steel wire, which is used to raise a load of 4000N if the stress in the rod is no…

A brass bar, having cross sectional area of 100mm2, is subjected to axial force of 50kN. The length of two sections is 1…

What will be the elongation of a bar of 1250mm2 area and 90cm length when applied a force of 130kN if E = 1.05x 105 N/mm…

A beam is said to be of uniform strength, if ________

In the given figure a stepped column carries loads. What will be the maximum normal stress in the column at B in the lar…

A composite bar consists of a bar enclosed inside a tune of another material when compressed under a load as whole throu…

A diagram which shows the variations of the axial load for all sections of the pan of a beam is called ________