Point A is pin joint and B is roller. A load of 40KN is applied at point C. Length of AC is 2m and d same goes for bea…

Reaction at the level of prop, at the free end of a cantilever of span I carrying a u.d.I. 'W' per unit length is</p&…

How many boundary conditions will be required to solve this question?

In general tA/B implies:-

Point A is pin joint and B is roller. A load of 40KN is applied at point C. Length of AC is 2m and d same goes for bea…

If area of M/EI diagram between points A and B is –ve, then angle from tangent A to tangent B will be measured :-

What is the dimension of θB/A if area is measured in SI unit:-

In the case of a beam simply supported at both ends, if the same load instead of being concentrated at centre is distrib…