A positive moment by standard sign convention would bend a horizontal beam:-

Following is a cantilever beam and its length is Z. A moment M is applied at the end B. E and I are given. …

What will be the modulus of slope at point D? B is a hinge support and C is roller support. A and D are free ends. A loa…

In the case of a beam simply supported at both ends, if the same load instead of being concentrated at centre is distrib…

What will be the value of second obtained constant?

Which of the following is correct boundary condition for a beam supported by pin at both ends?

Point A is pin joint and B is roller. A load of 40KN is applied at point C. Length of AC is 2m and d same goes for be…

Point A is pin joint and B is roller. A load of 40KN is applied at point C. Length of AC is 2m and d same goes for bea…