This type of rapid prototyping system uses a laser to fuse powdered metals, plastics, or ceramics:

This is a flat or rounded tab protruding from a surface, usually to provide a method for attachment:

Understanding the Cartesian coordinate system will help the beginning drafter __________.

In the section view, the areas that would have been in actual contact with the cutting plane are shown with:

Most architectural drawings produced for field use by building contractors are printed on architectural "D" si…

When only a small section of an interior area needs to be revealed the drafter can use a ________ section.

A partial auxiliary view is used to show only the __________ in the auxiliary view.

The Offset tool should only be used for placing _________ in an isometric drawing.