A cylinder can be created by drawing a rectangular shape then the ________ tool.

This is the term for the range of tightness or looseness resulting from the allowances and tolerances in mating parts:

Perspective drawings are classified according to their number of these features:

There should be a visible gap between the wall and the _________ line.

This type of thread is a thread on the inside of a member:

Approximately this much of the cost of product development and manufacture is determined at the design stage:

Several of the tools used in traditional drafting include the following:

In U.S. structural and architectural drafting, all dimensions of this length are usually expressed in feet and inches: