Given a situation in which the drafter has crossed extension lines in a drawing what can be done to clean up the point o…

When adding dimensions to an auxiliary view it will be necessary to use the ________ tool.

The ________ is a standard element of a section view in a technical drawing.

Architectural dimensioning standards allow for the placement of dimensions inside the floor plan. These inside dimension…

An engineer's scale would be used to measure lines on a drawing where the scale factor reads ________.

In this type of concrete, the steel is pre-tensioned before the superimposed load is applied:

Inserting blocks into a drawing file usually requires exacting placement. The drafter should insure that ________ is tur…

Placement of dimensions on a drawing is controlled by ________.