image Guest

You need to login to ask any Questions from chapter introduction-to-drawing of Engineering-Drawing

Chapter:

introduction-to-drawing

1. The section lines are generally drawn to horizontal lines at ___.


Hint Answer

2. The horizontal lines are drawn from ___ to ___.


Hint Answer

3. Sectional views reveal ___.


Hint Answer

4. A figure produced by a moving line is called a ___.


Hint Answer

5. When a point lies on reference line, its two views lie on ___.


Hint Answer

6. For ordinary sectioning, spacing varies between ___.


Hint Answer

7. An oblique solid is one which has its axis ___ to its base.


Hint Answer

8. The receding lines in an isometric projection are drawn ___.


Hint Answer

9. A corner is represented by a ___ in all three views.


Hint Answer

10. Freehand sketches are used for expressing and recording ___.


Hint Answer

Nexttt

All Chapters

View all Chapter and number of question available From each chapter from Engineering-Drawing

Topics

This Chapter introduction-to-drawing consists of the following topics

Introduction and Drawing Instruments

The section lines are generally drawn to horizontal lines at ___.

;

The horizontal lines are drawn from ___ to ___.

;

Sectional views reveal ___.

;

A figure produced by a moving line is called a ___.

;

When a point lies on reference line, its two views lie on ___.

;

For ordinary sectioning, spacing varies between ___.

;

An oblique solid is one which has its axis ___ to its base.

;

The receding lines in an isometric projection are drawn ___.

;

A corner is represented by a ___ in all three views.

;

Freehand sketches are used for expressing and recording ___.

;