Guest
Chapter:
simple-stress-and-strain
1. What will be elastic modulus of a material if Poisson’s ratio for that material is 0.5?
2. Some structural members subjected to a long time sustained loads deform progressively with time especially at elevated temperatures. What is such a phenomenon called?
3. What is limiting values of Poisson’s ratio?
4. The property of a material by which it can be beaten or rolled into thin plates is called ______
5. What is factor of safety?
6. The unit of force in S.I. units is ?
7. A bar of diameter 30mm is subjected to a tensile load such that measured extension on a gauge length of 200mm is 0.09mm and change in diameter is 0.0045mm. Calculate Poissons ratio?
8. A rod of length L and diameter D is subjected to a tensile load P. which of following is sufficient to calculate resulting change in diameter?
9. What is point P shown in stress-strain curve?
10. Find strain of a brass rod of length 250mm which is subjected to a tensile load of 50kN when extension of rod is equal to 0.3mm?
All Chapters
View all Chapter and number of question available From each chapter from Structural-Analysis
Simple Stress and Strain
Simple Stress and Strain
Stresses in Members
Stresses in Members
Strain Energy and Resilience
Strain Energy and Resilience
Center of Gravity and Moment of Inertia
Center of Gravity and Moment of Inertia
Shear Force and Bending Moment
Shear Force and Bending Moment
Pure Bending
Pure Bending
Shear Stress
Shear Stress
Direct and Bending Stress
Direct and Bending Stress
Slope and Deflection
Slope and Deflection
Indeterminate Beams
Indeterminate Beams
Torsion
Torsion
Plastic and Local Buckling Behaviour of Steel
Plastic and Local Buckling Behaviour of Steel
Cables and Arches
Cables and Arches
Influence Lines and Approximate Analysis for Statically Determinate Structures
Influence Lines and Approximate Analysis for Statically Determinate Structures
Deflections
Deflections
Deflections Using Energy Methods
Deflections Using Energy Methods
Displacement Method of Analysis: Slope-Deflection Equations
Displacement Method of Analysis: Slope-Deflection Equations
Displacement Method of Analysis: Moment Distribution
Displacement Method of Analysis: Moment Distribution
Influence line diagram mcqs
Influence line diagram mcqs
Structural engineering important exam questions
Structural engineering important exam questions
Structural engineering important exam questions II
Structural engineering important exam questions II
Structural engineering important exam questions III
Structural engineering important exam questions III
Plastic Analysis
Plastic Analysis
Structural Engineering Loksewa Questions
Structural Engineering Loksewa Questions
Topics
This Chapter simple-stress-and-strain consists of the following topics
Simple Stress and Strain
What will be elastic modulus of a material if Poisson’s ratio for that material is 0.5?
Some structural members subjected to a long time sustained loads deform progressively with time especially at elevated temperatures. What is such a phenomenon called?
What is limiting values of Poisson’s ratio?
The property of a material by which it can be beaten or rolled into thin plates is called ______
What is factor of safety?
The unit of force in S.I. units is ?
A bar of diameter 30mm is subjected to a tensile load such that measured extension on a gauge length of 200mm is 0.09mm and change in diameter is 0.0045mm. Calculate Poissons ratio?
A rod of length L and diameter D is subjected to a tensile load P. which of following is sufficient to calculate resulting change in diameter?
What is point P shown in stress-strain curve?
