Estimate the position and magnitude of the maximum transverse tensile stress and bursting tension for the end block with…

The main aim of stress analysis in the anchorage zone is to obtain ________

During anchorage of the end faces results in application of ________

The design strength assumed to act to sustain bursting tension is ________

The distribution of transverse stress and ultimate load of the end block is not effected by ________

The discontinuous forces applied at the end while changing progressively to develop ________

The tensile stresses which tend to split the concrete are placed in the transverse direction to the ________

If the centre to centre spacing of the anchorage devices will not exceed 1.5 times width then they are considered as ___…